Listo CHS L6 Notice D'utilisation page 12

USE
1. f
unction Selector Switch
This appliance is equipped with a function selector switch (4). The positions are:
0 Off
Ambient air ventilation
I 1000 W
II 2000 W
Make sure the function selector switch is in position 0 before plugging the appliance
into the power socket.
a
mbient air Ventilation
You can use the fan alone throughout the year thanks to the "cold ventilation" mode.
Set the function selector switch to "ambient air ventilation" position
the thermostat knob to the maximum position (in a lower position, the fan may not
operate).
c
hoice of power
Power consumption depends on the position selected (I or II) with the function
selector switch (3). To save energy, use position "II" (2000 W) first, then switch to
position "I" (1000 W) when the desired heat has been reached.
2. S
witching on
1. Place the heater on a flat, horizontal and stable surface.
2. Connect the power cord plug to a mains socket.
3. Select the heating power by setting the function selector switch (3) to position
"I" for 1000 W or position "II" for 2000 W.
4. Turn the temperature control knob (2) to the right until you hear a "click" (this
sound means the thermostat is on). The red power light comes on.
5. When the power light goes out, this means the appliance is in pause mode. The
fan heater automatically turns itself on and off to maintain the temperature set
by the temperature controller.
6. When you have finished using it, set the power selector knob to position "0" (off)
to stop the heater, then unplug the appliance from the power socket.
V.5.0
and set
22
MAINTENANCE AND CLEANING
This appliance must be maintained regularly to ensure proper operation:
Always unplug the appliance from the mains socket
•
before cleaning it.
Never immerse this appliance, the power plug or
•
cord in water or any other liquid.
Regularly clean ventilation grilles with a vacuum
•
cleaner to remove dust deposits.
• Use a slightly damp cloth to wipe the outside of the appliance.
• Never use aggressive cleaning products (alcohol, solvent, etc.) or abrasive
scouring sponges on this appliance.
• If necessary, you can use a soft sponge lightly soaked in water and a mild detergent
(e.g. washing up liquid) for thorough cleaning. Dry carefully with a soft cloth.
• In any case, make sure no water enters the appliance.
• Make sure the heater is completely dry before plugging it in again.
23 V.5.0