Flex FX5141 Manuel De L'utilisateur page 13

USING EXTENSION CORD (FIG. 3)
CAUTION
used at the same time.
a. To operate the light with AC power: Remove
the battery pack from the power bay.
b. Connect a suitable power cord (sold
separately) to the AC power inlet located in
the power bay. Please refer to "EXTENSION
CORDS" chapter earlier in this manual.
c. To disconnect the power cord, remove the
power cord from the power inlet.
TO ATTACH/DETACH THE LIGHT MODULE
TO THE TRIPOD (FIG. 4A, 4B, 4C)
WARNING
please make sure the tripod legs are fully
expanded and secured firmly in the locked
position.
To attach:
Align the raised rib on the light holder with the
grooves in the light module, and then slide the
light module onto the holder (Fig. 4a).
To detach:
Press the light release buttons inward to release
the light module. Pull the light module out and
remove it from the holder (Fig. 4b).
The extension cord and a
battery pack cannot be
Before attaching the light
module to the tripod,
Fig. 3
AC Power Inlet
Fig. 4a
Attach
Fig. 4b
Light Release Buttons
-13-
Light Module
Light Holder