Publicité
Les langues disponibles
Les langues disponibles
5.
Rotate side clips (3) into place to securely attach trim
assembly to LED engine (Figure 6.).
6.
Trim ring (optional) should be placed between the
ceiling and lower trim.
7 .
Properly align the connector as shown in (Figure 7 .).
Plug in the luminaire quick disconnect on the module.
8.
Ensure the connector is properly engaged. (Figure 8.).
9.
Install the LED engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 9.).
Figure 7
Figure 8
Figure 9
Installation Instructions – LD4B/LD6B Commercial Recessed LED Rough-In
Installation Instructions – LD4B/LD6B Commercial Recessed LED Rough-In www.eaton.com
Wall Wash Option
1.
For wall wash option install frame with junction box
toward wall. (Figure 10.)
2.
For wall wash option install trim assembly with gradient
kicker opposite wall to be illuminated. (Figure 11.)
Option 1
Wall
Figure 10
Gradient
Kicker
Figure 11
Option 2
Wall
Insert
Wall
3
Publicité
