Eaton Cooper Lighting Portfolio LSR6A Serie Instructions D'installation Et De Câblage

ADP142878
Installation and Wiring Instructions – DMX Driver Mount For 6" & 8"
Cylinders
Installation et instructions de câblage – Montage de circuit de sortie
DMX pour cylindres de 15 et 20 cm (6 et 8 po)
Instrucciones de instalación y cableado: Montaje del controlador
DMX para luminarias cilíndricas de 6" (152,40 mm) y 8"
(203,20 mm)
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
INSTALLATION
DMX Wiring Instructions:
This sheet only provides additional instructions for DMX
wiring.
Ceiling Mount Version:
1. Loosen four thumb screws on top of cylinder.
Remove driver bracket assembly from cylinder.
2. Fish DMX Cables through hole in mounting bracket
leaving approximately ten inches of wire. Connect
power and ground wires per wiring diagram in main
instruction sheet.
3. Mount driver bracket to J-Box mounting plate. (Refer
to main instruction sheet for mounting details).
4. Connect DMX cables to Driver(s) per DMX wiring
standards.
5. Secure cylinder to driver bracket with thumb screws.
For complete installation instructions, please refer to main
instruction sheets.
Catalog Number
LSR6A*
LSSQ6A*
LSRWM6A*
LSSQWM6A*
LSR8A*
LSRWM8A*
Main Instruction Sheet
INS ADP142624
INS ADP142625
INS ADP142626
INS ADP142627
Wall Mount Version:
1. Loosen four thumb screws on top of cylinder. Remove
driver bracket assembly from cylinder.
2. Mount fixture to wall, Fishing power, Ground and
DMX cable through mounting arm and out top of
cylinder, leaving approximately 10 inches of DMX
cable.
3. Connect power and ground per main instruction
sheet.
4. Connect DMX cables to Driver(s) per DMX wiring
standards.
5. Mount driver bracket to cylinder with 4 thumb screws.
N ote: Based on cylinder construction, one or two drivers
may be present. Please refer to appropriate wiring
diagram in main instruction sheets.
Driver
Bracket
DMX
Assembly
Driver
Cylinder
DOUBLE DMX DRIVER MOUNT
TM
INS #
SINGLE DMX
DRIVER MOUNT