Software Updates; Volfoni Loader - Parameters - Volfoni EDGE Universal VPEG-04010 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

It is also possible to see the exact level of your glasses'
battery charge by connecting to your computer and
using the Volfoni Loader (see section Advanced settings
via Volfoni Loader).
Once the glasses are recognized,the level bar is
displayed.

5. SOFTWARE UPDATES

Before using the EDGE
TM
have the latest version of software from our website. For
this purpose, please download the « Volfoni Loader »
software (http://www.volfoni.com/en/services-support/
download) and connect your glasses to your computer.
Then start the software and follow the instructions below.
- choose the menu "SUPPORT"
- choose "Upgradable Software"
- download the application "VOLFONI LOADER"
- connect your computer to the μUSB connector on the
arm of the EDGE
Universal with the USB/μUSB cable
TM
- press and hold the ON/OFF button of the EDGE
during 3 seconds.
- the LED of the EDGE
TM
- verify that the application recognizes your system
- once you are connected, press the button "Check for
updates"
- download the lastest version
10
Universal glasses, make sure you
Universal will light red

6. VOLFONI LOADER - PARAMETERS

You can access to this part by clicking on "parameter"
in the menu "edit"
You must be in "Bootloader Mode" so that the EDGE™
Universal is recognized by the software.
To do this, once the USB/μUSB cable is connected to
VR
TM
the computer, press and hold the ON/OFF button for 3
seconds.
Switch Pos (A, B or C) :
- 3D on all positions : In this configuration the glasses will
receive a normal 3D sync whatever the switch position
- 3D Reverse : In this configuration the glasses will receive
a reverse 3d sync whatever the switch position
- Shared screen : In this configuration
Switch in A position : 3D
Switch in B position : 2D left
Switch in C position : 2D right
11

Publicité

Table des Matières
loading

Table des Matières