Powers P180 Mode D'emploi page 21

Operation
Triaxial vibration emission level deter-
mined in accordance with EN 60745.
K = Measurement uncertainty value
Triaxial vibration emission value in
m/s²: Screws
Triaxial vibration emission value in
m/s²: Drilling metal
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and accessories, keep the hands
warm, organisation of work patterns.
Chuck opening range ø in mm
Drilling in steel - max. ø in mm
Fitting screws in wood - max. ø in mm
Drilling in wood - max. ø in mm
Weight in kg
Battery
Rated voltage of battery in V DC
Capacity in Ah
Battery with lithium-ion technology
Battery charger
Mains voltage in V~ / Frequency in
Hz
Charging voltage in V DC.
Charging current in A
Operating temperature range in °C
XX
Battery charging time in min.
Your battery charger is double-insu-
lated in accordance with EN 60335.
For this reason an earth wire is not
required.
The device is suppressed against radio and TV
broadcasts, in accordance with EN 55014-1 and is
immune to disturbances in accordance with
EN 55014-2.
4. Operation
Remove the battery from the device
before undertaking any work on the
device.
This safety measure prevents acciden-
tal starting of the power tool.
Start-up
Charge battery
Insert battery
-WARNING-
Use only original Powers batteries with the
voltage given on the type plate of your machine.
Use of any other batteries may lead to the risk of
injury or fire.
Use only the battery chargers and batteries
listed in the illustrated instructions.
Only these battery chargers and batteries are tai-
lored specifically to your power tool.
English 21
EN
Akkuschrauber-EN / 1006