Neen Peritone Mode D'emploi page 13

Electrodes placed on the legs, arms, face buttock or pelvic area use WIDE
BAND setting. All other areas i.e. abdomen, chest, shoulder, upper arms
and back use the NARROW BAND setting.
Narrow band setting is used due to the interference from the electrical
activity of the heart which needs to be eliminated from the EMG signal.
Pressing the ESC button will record and store the parameters that have
just been set until it is reprogramed. To start the program press the START
button, to escape press the ESC button.
At the end of each session for example Work 5 seconds, Rest 5 seconds
and 5 trials (Repetitions) the LCD display will highlight the statistics
(described on page 15 and 16). The results will differ from one patient
to another.
EMG Statistics.
Once a session has finished WAV will appear on the screen.
Press the SET button consecutively to read all the statistics.
Press SET
to see:
WAV
This is the work average for the session measured in (µV) microvolts.
Average readings will vary from one patient to another.
RAV
This is the rest average for the session measured in µV - Below 4 µV
a muscle is beginning to rest.
OST
This is the average onset of muscle contraction measured in seconds,
readings below 1 second can be considered normal.
RLS
This is the average muscle release measured in seconds, readings
below 1 second can be considered normal.
When you have completed reading the statistics you can either continue to
press the SET button to read the statistics again or press the ESC button to
come out of the program. NOTE: Once you have pressed the ESC button you
will lose all the information.
If you are linked to a PC the statistics can be saved for future reference.
PERITONE Instruction Manual - GB
13