Publicité
Les langues disponibles
Les langues disponibles
Fax +32 2 359 95 50
PREPARATION OF COFFEE
Open the lid of the water tank and pour the desired volume of water in
•
it. The water level can be read off the water level indicator. Never
exceed the maximum level indicated.
Insert filter paper in the filter holder and add the desired quantity of
•
ground coffee using the provided scoop.
Never forget to close the water tank lid before switching on the coffee
•
maker.
Put the jug with closed lid on the hotplate.
•
Plug in the coffee maker. Press the ON/OFF button once. The red RUN
•
light, will be illuminated, indicating that your appliance is in use. Thanks
to the keep warm function, your coffee stays warm as long as the
appliance is switched on (for 2 hours, unless coffee maker gets switched
off by user)
Your coffee maker is equipped with a "Pause-and-Serve" function,
•
which means that when you remove the jug from the appliance, a non-
drip valve will automatically operate to stop any drops of coffee falling
onto the hotplate. When you put the jug back into place, the non-drip
valve opens automatically and allows remaining coffee to filter through
into the jug.
Wait until the brewing process is finished and the filter is empty before
•
removing the jug.
Practical hints: When the water tank is empty, wait a few more minutes,
•
as some water might still drip out of the filter before removing the jug.
Note: a 2-hour auto-shut off feature is activated when operating the
•
coffee maker manually
PROGRAMMING THE COFFEE MAKER
To program your coffee maker to brew fresh coffee at a preset time, first
•
follow steps 1 to 4 in the "PREPARATION OF COFFEE" section.
Make sure the coffee maker's clock is set to the right time.
•
Press the PROG button twice. The clock will now display 12:00 with the
•
word "TIMER" in the upper left corner. Use the HOUR and MINUTE buttons
to set the desired brew time. Press PROG to validate the timer setting.
Press the START/STOP button twice to activate the preset brew cycle.
•
The green AUTO light will illuminate when the brew time is properly set.
When your preset brew time is reached and the coffee maker starts its
•
brew cycle, the green AUTO light will go out and the red ON light will
illuminate.
As with the regular brew cycle, an automatic two hour keep warm
•
cycle will commence after your coffee maker has finished brewing. At
the end of the two hours, the coffee maker will automatically shut itself
off.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/24
special
instruction
from
Team
Print only
USK CM 25282 - 111026
Publicité
