Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig. C
10
9
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. D)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
14
and the other hand on the side handle.
Fig. D
5
WARNING: To reduce the risk of serious personal
injury, read, understand and follow all safety
warnings and instructions prior to using tool.
WARNING: It is important to support the work
properly and to hold the drill firmly to prevent loss of
control which could cause personal injury. If you have
any questions on how to properly operate tool, call:
1-800-544-6986.
WARNING: Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to
the chuck and personal injury may occur when
changing accessories.
WARNING: To reduce the risk of injury, always
unplug drill from power supply before making any
adjustments or changing accessories.
WARNING: To reduce the risk of injury, let the tool
work at its own pace. Do not overload.
7
14
Selecting the Direction of Rotation
(Fig. E)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
WARNING: Never change the direction of rotation
while the motor is running.
•
To select forward rotation, push the forward/reverse
slider
3
to the left (when viewed from the chuck end).
•
To select reverse rotation, push the forward/reverse
slider
3
to the right (when viewed from the chuck end).
Fig. E
Selecting the Drilling Mode
•
For drilling in masonry, set the drilling mode selector
to the "hammer symbol"
•
For drilling in other materials and for screwdriving,
set the drilling mode selector
position.
Setting the Drilling Depth (Fig. F)
•
Slacken the side handle
5
counterclockwise.
•
Set the depth stop
8
to the desired position. The
maximum drilling depth is equal to the distance
between the tip of the drill bit and the front end of the
depth stop.
•
Tighten the side handle by turning the grip clockwise.
Fig. F
8
5
Switching On and Off
WARNING: The drill should only be locked ON when it
is held stationary in a drill press stand or other means;
NOT BY HAND! Never unplug the tool with the locking
feature engaged. To do so will cause the tool to start
immediately the next time it is plugged in.
English
3
4
position.
4
to the "drill symbol"
by turning the grip
5
Publicité
Table des Matières
