Christopeit Sport BT 2 Notice De Montage Et D'utilisation page 16

Step 4:
Attach the computer (1) at handlebar support (68).
1. Put the plug of the connecting cable (67) projecting from the handlebar
support (68) into the computer connection cable (2).
2. Put the plugs of the pulse cables (74) projecting from the handlebar (73)
into the pulse connection cables (3).
3. Place the computer (1) on the plate provided for it on the handlebar
support (68) and attach it with the screws (69).
Step 5:
Installation of saddle (9), saddle slide (10) saddle support (15).
1. Push the saddle (9) with saddle bracket into the movable saddle slide
(10) and tight it up with washer (11) and nut (80).
2. Place the movable seat slide (10) into the holder of saddle post (15), set
it at the desired horizontally position and tighten it by washer (12) and
movable seat knob (13).
3. Insert the saddle support (15) into the provided holder of the main fra-
me (43) and secure at the desired position by screwing in the rapid-
action lock (66).
(Note: To screw in the rapid-action lock (66), the threaded hole in the
main frame (43) and one of the holes in the saddle support (15) must be
aligned. Furthermore, ensure that the saddle support (15) is not pulled
out of the main frame (43) beyond the marked maximum position. The
setting of the saddle post can be adjusted as desired later. For this,
the rapid action catch (66) must be loosened by only a few revolutions,
the cap of the lock must be pulled away and the saddle adjusted. Then
secure the new setting by tightening the rapid action catch.
16