General safety instructions
2.2
Safety when installing the device
DANGER!
D
Never mount the device anywhere where there is a risk of gas
or dust explosion.
CAUTION!
!
Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
NOTICE!
A
Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
Set up the device in a dry location where it is protected against
splashing water.
2.3
Safety when connecting the device electronically
DANGER! Danger of electrocution
D
For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the device installed by a specialist
(marine) electrician.
If you are working on electrical systems, ensure that there is
somebody close at hand who can help you in emergencies.
WARNING!
!
Always use sockets which are grounded and secured by
residual current circuit breakers.
Make sure that the lead has a sufficient cross-section.
Lay the cables so that they cannot be damaged by the doors or
the bonnet.
Crushed cables can lead to serious injury.
CAUTION!
!
Lay the cables so that they cannot be tripped over or damaged.
40
MCA1215 – MCA2440
EN