Configuration Of Computer Sources - Sagem Axium HTD501 Manuel D'utilisation

7.3.

Configuration of computer sources

IMAGE AUDIO
HORIZONTAL
CODE CODE
SAISIR
VERTICAL
PROTECTION VERROU
FREQUENCY
SOURCES CHAINE
PHASE
PC DATA MODIF. CODE
MODE HP INT.
AUTO IMAGE
SEARCH CONFIG. USINE
OPTIONS INSTAL.
5
CODE CODE
10
PROTECTION _ _ _ _ VERROU
-3
SOURCES CHAINE
0
DONNEES PC MODIF. CODE
YES
RECHERCHE CONFIG. USINE
Press the MENU button, then choose "INSTAL" using
the B button and validate with OK.
Choose "PC DATA" then validate with OK.
This option allows you to adjust the source coming from
your PC in VGA mode. (Entries in DVI D mode do not need
this adjustment).
Horizontal position: press C to move the picture to the
left and B to move it to the right.
Vertical position: Press B or C to move the picture to
the top or bottom.
Frequency: modifies the data display frequency so that it
corresponds to the frequency of your computer's graphics
card. When a flashing vertical bar appears, use this function
to adjust the frequency.
Phase: this enables finer synchronisation with your
computer's graphics card. When an unstable or flashing
page occurs, use this tuning.
Automatic mode: yes/no carries out automatic tuning.
Resolutions accepted (DVI-D and VGA entries)
To ensure that the projection display is operating correctly
with your computer make sure that you configure the
display mode of your graphics card to a resolution lower
than 1024 x 768.
Horizontal Vertical
640 x 480
640 x 480
640 x 480
640 x 480
640 x 480
800 x 600
800 x 600
800 x 600
800 x 600
1024 x 768
1024 x 768
1024 x 768
1152 x 864
1152 x 864
1280 x 720
1280 x 1024
NB: Optimum stability is achieved with a frequency of 60 Hz
(consult the documentation for your PC to configure it).
14
Hz
60
66
72
75
85
60
72
75
85
60
70
75
60
70
60
60