Transport And Installation; Transport; Installation; Use - KE Gennius I2 Manuel D'utilisation Et D'entretien

Use and maintenance manual
5.

TRANSPORT AND INSTALLATION

5.1 Transport

Transport and shipping are the responsibility of the reseller and/or the manufacturer, who shall transport the
product using packaging suitable to protect it up until delivery to the end customer.
Damage to the product sustained during removal of the structure and subsequent handling and/or
transport, performed after the initial installation, is not covered by warranty.
The packaging material must be disposed of and/or recycled pursuant to applicable local legislation.

5.2 Installation

• Assembly of the components, installation and first start of the product must only be
performed by specialised and qualified technicians, and is the responsibility of the reseller
and/or manufacturer.
All instructions and the main safety standards for performing these operations are described in the "Assembly
Manual" and the "Installer Manual".
The position chosen by the user for installation of the product must provide adequate support as well as the
space necessary for the structure to open fully (see "Installer Manual").
6.

USE

• Before operating the structure, read Chapter 2 "Safety" and Chapter 3.2 "Intended Use
and Installation Location" thoroughly.
• Ensure there are no persons or objects obstructing or excessively close to the structure's
moving parts when opening and closing.
• The structure must always open from the top downwards, never the contrary. Danger of
breakage, with risk of serious personal injury.
• Use the structure as described in Chap. 3.2 "Intended use and area of use".
• It is strictly prohibited to climb on or hang/place any objects from/on the structure.
• If mould should appear on the awning, clean as described in Chapter 7.2 "Cleaning".
The structure can be opened and closed via:
• A SWITCH installed near the structure in a position providing the user with full visibility of the same during its
movement. If installed outdoors, the switch must have appropriate ingress protection.
• A REMOTE CONTROL, portable or wall mounted.
The characteristics and operation of these systems are described in the manuals, supplied as annexes, for the
requested controls, motor and automatic devices.
In the event of faults or malfunctions, contact your reseller.
rev.00 23-09-16
I2 - I2A
7