Marmitek IP ROBOCAM 8 WIRELESS Guide D'installation Rapide page 3

SAFETY WARNINGS
• To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the
components to rain or moisture. Do not use the product close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright light sources.
• Do not open the product: the device contains live parts. The product should only be repaired or serviced by a
qualified repairman.
• In case of improper usage or if you have opened, altered and repaired the product yourself, all guarantees
expire. Marmitek does not accept responsibility in the case of improper usage of the product or when the
product is used for purposes other than specified. Marmitek does not accept responsibility for additional
damage other than covered by the legal product responsibility.
• Adapters: Only connect the adapter to the mains after checking whether the mains voltage is the same as the
values on the identification tags. Never connect an adapter or power cord when it is damaged. In that case,
contact your supplier.
SYSTEM REQUIREMENT
• 10 Base-T Ethernet or 100 Base-TX Fast Ethernet
• CD-ROM drive
• CPU: Intel Pentium II 266MHz or above
• Memory: 32MB (64MB recommended)
• VGA resolution: 800x600 or above
PACKAGE CONTENTS
• One Pan/Tilt Internet Camera
• One AC Power Adapter
• One RJ-45 Ethernet Cable
• One externe antenna
• One Metal Clip
• This Quick Installation Guide
• One Installation CD-ROM
Note: If any item contained is damaged or missing, please contact your local dealer immediately.
This is the quick installation guide describing how to connect the IP Robocam. For an extensive description of all
the possibilities of the camera, consult the user manual, which can be found on the CD ROM provided.
HARDWARE INSTALLATION: ATTACHING THE METAL CLIP
To attach the metal clip, remove the two rubber pads under the
base of the camera firstly. Place the metal clip
onto the camera base, and align the two holes of metal clip
with two screw holes on the base. Secure the
metal clip to the base with two screws (provided). Then, you
can: install the camera to the ceiling using two
ceiling screws (1); or, install the camera to the wall using
two wall screws (2).
CONNECTING THE ETHERNET CABLE
Connect an Ethernet cable to the network cable connector
located on the camera's rear panel, and then attach it to
the network.
IP ROBOCAM8 WIRELESS
tm
3