Upholstery; Settings Of The Desired Shape; Adjustment Of The Seat; Components - Vermeiren PEPI Mode D'emploi

E

UPHOLSTERY

The frame is padded with upholstery made of water-permeable sieve cloth. The pressure of the cloth
can be adjusted with belts with velcro fastenings.
The stabilisation of the child is ensured by belts with velcro fastenings, which make it possible to
adjust the pressure easily to the child's needs, thus protecting the child against consequences of
uncontrolled movements. These belts can be relocated in any manner thanks to two sewn-in belts
running along the entire deckchair. The deckchair is provided with a hip belt and two belts for
stabilisation of legs.

SETTINGS OF THE DESIRED SHAPE

Hinges (5) are used for setting the desired angle between parts of the deckchair frame. In order to
change the angle of the selected frame segment, press the button of the relevant hinge (at the same
time on both sides of the frame) and set the desired angle, and then release the buttons.
The headrest can be inclined backwards at any angle for easier movement of the head. This solution
makes it also easier to wash the child's head. If there is a need to immobilise the head, this is done by
means of two braces attached to two belts running along the entire deckchair. If the use of braces is
not required, the headrest part is covered by soft foam so that the child could rest its head safely and
comfortably.

ADJUSTMENT OF THE SEAT

The deckchair construction makes it possible to adjust the depth of the seat.
In order to set the desired depth of the seat, unscrew 4 screw caps (7) and remove four screws (6)
from hinges (5), and then change the position of hinges on the seat pipe (2) as appropriate so that one
of the two holes on both ends of the pipe (2) suits the relevant hole of the hinge (5), then put the
screws (6) again in hinge holes, place the pads and screw caps (8 and 7) and fasten the whole
construction tightly.

COMPONENTS

1. Aluminum frame
2. Sieve cloth upholstery
3. Two belts for stabilisation of legs
4. Hip belt
5. Two head-stabilising braces
6. Operating manual
TECHNICAL DETAILS
(Given for the fully-assembled, standard version). Please note that adding accessories will alter the technical details
accordingly.
Total width
Seat depth
Length of the total lying area
Length of the support
Maximum load
Weight
We reserve the right to introduce technical changes. Differences of +/- 1.5 cm/kg, 1.5° are possible.
PEPI
38 cm
20 cm
110 cm
63 cm
30 kg
3,7 kg
3
PEPI
04/2010