Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
introduce the shank and use the pin for
the positioning.
Then tighten the 4 screws of fixations
(Important, watch that the screws have
the same strength of tightening).
Finally, add the M8 screw and washer
and tighten.
2. Adjust the offsets of 4 positions.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
BSE-3207-III
3. During the mounting or the
4. The tool shank diameter should never have
a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
NOTE :
positions. Use the supplied protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation: 03.05.13
dismounting of your cutting tools, block
the broach on flats planned for that
purpose, using the supplied spanner.
Never use the tool holder with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document:
BSE-3207-III Mode
d'emploi 1-.docx
Page: 2 de 4
Publicité
