Publicité
Les langues disponibles
Les langues disponibles
2. Charger „Li-Po Charger 2S"
First connect the charger with the current sour-
ce and afterward the batterie with the charger.
During charging process the LED will light red,
changing to green as soon as the batterie is full
again.
Also watch the safety instructions for Li-Po bat-
teries.
Connect the plug to a cars
12Volt cigarette lighter.
3. Running on water
Attention:
To operate on water remove the brake pad. Unscrew the
screw on the underside of the hovercraft, remove the black
plastic part with the brake pad and screw the lower and
upper shell together again.
To protect the electronics from splash water we suggest to
put the receiver into a balloon and to seal the electronic
compartement watertight with adhesive tape.
Do not put the ESC into a balloon, since the ESC can get very
hot.
Be aware that all failures due to water are not covered by
warranty.
Never run your hovercraft in the swell or strong breezes.
Connect to the
charger plug
Remove screws
Brakepad
Remove brakepad, and retighten the
screws
Publicité
