Programming The Receiver - Schwaiger ALPHA 100 Mode D'emploi

Select Channel number to be programmed.
Press „SET" key to get into set mode.
LNB input and Satellite Selection
Use „+/-" key to select between satellites. See notes below.
Corresponding DiSEqC are generated at each key pressing.
Polarity and 22KHz Tone Switch selection
Use „LNB" key to select for 4 kinds of polarity and 22KHz tone switching.
Corresponding DiSEqC are generated at each key pressing.
The established signalling method of 13/17VDC and 22KHz Tone are co-existed
with DiSEqC in this receiver. Therefore, you can use either DiSEqC, or 14/18VDC
signalling method, involuntarily.
No DiSEqC ON/OFF operation are required
Use of DiSEqC 1.0 switch
Press „SET" key to get into set mode.
Use „SAT" key to select between 4 kinds of DiSEqC switching. The following table
shows the display of these 4 switches and their corresponding DiSEqC commands:
DISPLAY
1. _XX
1. CXX
2. _XX
2. CXX
A Tone burst, corresponding to the position command, is sent along with the DiSEqC
commands. Therefore a tone burst switch can work with this receiver as well.
Press „ENT" key to store the proper DiSEqC switch with each channel in the
memory.

Programming the Receiver

DiSEqC 1.0 commands
OPTION SATELLITE
A
A
B
B
19
TONE BURST
A 0
B 1
A 0
B 1