AEG MRC 4122 F N Mode D'emploi page 70

English
70
Manual
When the device is searching for a radio signal, it is not possible to adjust the time manu-
ally.
1. Press the button (3) to switch the device into standby mode.
2. Press and hold the SNOOZE/SLEEP / DIMMER button (2). The " " symbol starts
flashing in the display.
3. Press and hold the SNOOZE/SLEEP / DIMMER button again. The " " symbol disap-
pears from the display.
4. Hold the SET/MEM/M+ button (1) depressed until the year indication (YR) on the
display flashes.
• Now you can set the year (YR), the month (M), the day (D), the time display format
(12Hr/24Hr), the hours, and the minutes with the buttons
• In each case, confirm the input with the SET/MEM/M+ button. The current indication
to be set flashes on the display.
NOTE:
• The input is stored automatically within approximately 30 seconds when no button is
pressed.
• With a 12 hour display the following is displayed: PM = Afternoon
• Setting of the weekday is done automatically.
Radio station tuning
1. Use the (7) and
of the buttons pressed, the device searches for the next radio station. The display
shows the tuned frequency.
2. If reception is too weak, change the position of the dipole antenna in order to improve
the reception.
Preset stations
You can preset up to 10 radio stations.
1. Search for a station as described under "Radio station tuning".
2. Keep the SET/MEM/M+ button (1) pressed. The preset location indicator flashes on
the display (e.g. P02).
3. Use the (7) and
4. Press the SET/MEM/M+ button to preset the station.
Y-M-D (8) buttons to tune the desired station. If you keep one
Y-M-D (8) buttons to select the desired preset station memory.
(7) and Y-M-D (8).