Setting The Network - Samsung LE40B651 Mode D'emploi

N
Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer is
currently being used by another device nearby, this will result in interference and communications may fail.
N
If you apply a security system other than the systems listed blow, it will not work with the TV.
•
When applying the security key for the AP (wireless IP sharer), only the following is supported.
1) Authentication Mode : OPEN, SHARED, WPAPSK, WPA2PSK
2) Encryption Type : WEP, TKIP, AES
•
When applying the security key for the Ad-hoc mode, only the following is supported.
1) Authentication Mode : SHARED, WPANONE
2) Encryption Type : WEP, TKIP, AES
N
If your AP supports WPS(Wi-Fi Protected Setup), you can connect to the network via PBC (Push Button Configuration) or
PIN (Personal Indentification Number). WPS will automatically configure the SSID and WPA key in either mode.
N
If the device isn't certified, it may not connect to the TV via the 'Samsung Wireless LAN Adapter'.
¦

Setting the Network

❑
Network Type
Select Cable or Wireless as the method to connect to the network.
N
The menu is activated only if the 'Samsung Wireless LAN Adapter' is connected.
Cable
■
Connect to the network using a cable.
■ Wireless
Connect to the network wirelessly.
❑
Network Setup
■ Cable Network Setup
(when Network Type is set to Cable)
N
Please check if the LAN cable is connected.
● Internet Protocol Setup → Auto / Manual
●
Network Test: You can test or confirm the network connection status after setting up the network.
N
When unable to connect to a wired network
If your Internet service provider has registered the MAC address of the device used to connect to the Internet for the first time
and authenticates the MAC address each time you connect to the Internet, your TV may not be able to connect to the Internet
as the MAC address differs from that of the device (PC).
In this case, ask your Internet service provider about the procedures to connect devices other than your PC (such as your TV)
to the Internet. If your Internet service provider requires an ID or password to connect to the Internet (network), your TV may
not be able to connect to the Internet. In this case, you have to enter your ID or password when connecting to the Internet
using an Internet Sharer (Router).
The internet connection may fail due to a firewall problem. In this case, contact your Internet service provider. If you cannot
connect to the Internet even if you have followed the procedures of your Internet service provider, please contact Samsung
Electronics.
Cable Network Setup-Auto
If you connect the LAN cable and it supports DHCP, the Internet Protocol (IP) Settings are
automatically configured.
1. Set Network Type to Cable.
2. Select Cable Network Setup.
3. Set Internet Protocol Setup to Auto.
N
The Internet Protocol is set automatically.
4. Select Network Test to check the network connectivity.
English - 26
Broadcast
Security
Network
General
Cable Network Setup
Internet Protocol Setup : Auto ▶
Network Test
IP Address :
Subnet Mask :
Gateway :
DNS Server :
U Move E Enter R Return
▶