Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
1. PACKAGE CONTENTS
The package contents:
•
1x TEXIBLE Wisbi
•
1x TEXIBLE Wisbi
(compatibel with ELDAT EasyWave
Receiver)
2. SCOPE OF APPLICATION AND FUNCTION
TEXIBLE Wisbi is the innovative nursing care product that stands
out for its ability to automatically signal an alarm when moisture,
body fluids or a bed exit are detected.
The sensor textile is used in a wide variety of nursing applications,
such as senior and nursing homes, assisted living and family care.
The necessary basic care, as well as the incontinence care and
the supervision of demented and fall-endangered residents
represents an increased care effort for all persons involved.
TEXIBLE Wisbi offers the right support here. The system allows an
optimal skin climate and minimizes the risk of running away.
3. PUTTING TEXIBLE WISBI INTO OPERATION
The TEXIBLE Wisbi transmitter is equipped with an 868MHz
EasyWave
Radio transmitter and forms a call system with an
®
ELDAT receiver. Every 2 seconds a measurement is made. Upon
detection of a wet bed pad or a bed exit, an alarm is sent via radio.
1. INSERT BATTERIES: Insert three mignon batteries (AA) into
the battery compartment. When the batteries are inserted
correctly, the white LED flashes briefly.
Switch the TEXIBLE Wisbi transmitter on through pressing the
button
once. The white LED flashes.
2. CONNECTION BED PAD: Place the bed pad as the top layer on
the sheet. White cotton side up, blue side down. Then fasten
the TEXIBLE Wisbi transmitter using the push buttons with the
bed pad.
(See image below)
3. CONNECT RECEIVER WITH TRANSMITTER:
– Bed Pad
®
Plus – Transmitter
®
4. ADDRESS CHANGE OF THE TRANSMITTER:
®
5. ALARM SETTINGS OF TEXIBLE WISBI TRANSMITTER:
Put the Eldat Receiver into operation in accordance with
the accompanying operating instructions and activate the
„teach-in mode" of the receiver.
Pair the TEXIBLE Wisbi Plus Transmitter with the ELDAT
receiver within 20 seconds by pressing the button
seconds.
If several EasyWave radio transmitters are in use, it may be
the case that the factory-set addressing of the TEXIBLE Wisbi
transmitter is identical to other devices. In this case, the radio
address of the TEXIBLE Wisbi transmitter must be changed.
To do so, open the 4 screws on the rear support cover. The
address can then be changed in the viewing window via the
DIP switch (Number 1 - 4).
You can now close the support cover once again and coup-
le the TEXIBLE Wisbi transmitter as described in Section 3:
„Connect Receiver with Transmitter".
The alarm settings (occupancy detection ON/OFF, delays) of
the transmitter can be customized to your Needs:
To do so, open the 4 screws on the back Support coverage.
The address can then be changed in the inspection window
via the DIP switch (Number 5 and 6).
Alarm WET and OCCUPIED
immediately
Alarm WET immediately and
OCCUPIED deactivated
Alarm WET immediately and
OCCUPIED 5 minutes delayed
Alarm WET immediately and
OCCUPIED 15 minutes delayed
Then close the support cover again.
for 3
Publicité
