D-Link DNS-722-4 Guide D'installation page 11

6. Lock the faceplate to secure the HDDs.
Connect the Ethernet Cable
Connect an Ethernet cable to the Ethernet
port. Connect one end of the Ethernet
cable to the NVR. Connect the opposite
end of this cable to a Gigabit Ethernet
LAN port of a router or a switch, or directly
to a computer.
Connect the UPS (Optional)
If you have a Universal Power Supply
(UPS) that you would like to use with the
NVR, you may connect it before powering
the unit on.
1. Connect the USB cable from the UPS to
the port on the back of the NVR.
2. Connect the power cable to the UPS.
(Ensure that the UPS is plugged in and
receiving power.)
Note: To turn off the NVR, simply push the power button for 5 seconds. The
power LED will blink and the NVR will turn off after a moment.
D-Link DNS-722-4/726-4 Quick Install Guide
10