Buffalo CW305 Mode D'emploi page 4

UK
Operation
Water reservoir
Top hotplate on
indicator light
Brewing Indicator
light
Bottom hotplate on
indicator light
Power switch for
bottom hotplate
(Main switch)
Preparation before first use
BUFFALO recommend that the appliance is cleaned out before using for the first time, or if the appliance
has been sat unused for an extended period of time.
1. Slide the empty filter basket into position between the two basket tabs.
2. Place the jug on the bottom hotplate beneath the basket.
3. Fill the water reservoir with cold water.
Note: Use the jug to fill the reservoir to ensure it's maximum capacity is not
exceeded. The maximum amount of water the reservoir can contain is 1.8 litres.
If too much water is filled, excess water will drain out through the overflow
pipe.
4. Connect to the mains power supply.
5. Turn the main switch
6. Press the brewing button. The brewing indicator light illuminates and the hot water will begin to fill
the jug.
Note: During operation, steam may rise from the appliance and loud bubbling
noises may be heard. This is perfectly normal.
4
CW305_ML_A5_v4_20210218.indb 4 CW305_ML_A5_v4_20210218.indb 4
On. The indicator light for bottom hotplate is on.
Top hotplate
Power switch for
Top hotplate
Brewing button
Filter basket
Jug
Overflow pipe
Bottom hotplate
2021/2/18 14:40 2021/2/18 14:40