Rowenta RW5360 Mode D'emploi page 18

NOT RF7360-5360-3330 017276 6/02/07 9:26 Page 14
7. CLEANING AND CARE INSTRUCTIONS
Clean the shaver after each use!
• Dry cleaning
- Stop and unplug the appliance.
- Press both release buttons (E) and lift up the shaving head (fig 1)
- Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)
- Brush the shaving unit with the cleaning brush supplied. Also clean the area under the
cutting unit and brush clean the upper cover (fig 5).
• Cleaning with water
- Stop and unplug the appliance.
- Press both release buttons (E) and lift up the shaving head (fig 1)
- Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)
- Press both release buttons (E) and lift up the shaving head (fig 1)
- Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)
- Rinse the foil mesh and the cutting unit under running water (fig 14).
Remove remaining hair with the brush. Let the shaver dry before closing the shaving
head.
- The housing may be wiped down using a damp cloth with a little washing-up liquid.
- Replace the head on the shaver by pushing it into the upper part of the housing and
then pressing it into the housing until it clicks (fig 2&3).
RINSING THE BIKINI HEAD (RF7360)
- Stop and unplug the appliance.
- Remove the bikini head by pressing the release buttons on the shaving head (E) and
pulling the head gently upwards (fig 12).
- You can then put the bikini head under gently running cold water for 5 to 10 seconds .
- Shake the bikini head briskly then dry it with a towel.
- Replace the head on the shaver by pushing it into the upper part of the housing and
then pressing it into the housing until it clicks (fig 2&3).
WASHING THE COMBS AND BIKINI ACCESSORY
- Put them under gently running cold water then dry them with a soft cloth before
storing.
8. IN THE EVENT OF A PROBLEM
• "Inefficiency of your shaver!":
- Have you thought of stretching your skin during shaving?
- Have you cleaned the shaving head properly? Is it worn?
- Is the shaving head worn? To change it, go to one of our approved service centres.
- Is the cutting head well positioned in its housing?
14