Virax VAL 80E Manuel D'utilisation page 15

EN
HOW TO REMOVE THE DRUM FROM THE MACHINE
1. Loosen the front post knob and swing Power Cable Feed out of the way.
2. Remove the drive belt. You may relieve tension on the belt by applying pressure to the motor which is
spring-mounted.
3. Locate the holding latch behind the drum. Pull the drum forwards, whilst pulling on this latch to remove it
from the machine.
4. The drum can be replaced by repeating these procedure in reverse order.
HOW TO USE THE 291223 DRUM
The 291223 drum is for use with Ø 6.35 or 8 mm cables. These cables are fitted with a sink U-bend head that can pass
through most U-bend fittings.
To install the cable, fully open the jaws of the chuck such that the cable may pass freely.
Tighten the chuck when working on difficult obstructions or tight bends to avoid the cable becoming entangled inside the
drum.
Regularly clean and lubricate the chuck against rust.
CARE AND MAINTENANCE
IMPORTANT: Pull the mains plug before carrying out any work on the machine! Clean the machine at regular intervals.
For your machine to function correctly, it is essential that all bearings and cables are lubricated with VIRAX
290400 specific drain cleaning machine oil. It is especially important to lubricate all moving parts when the
machine is used in an environment where sand, dirt or other abrasive materials are present.
All other servicing, maintenance and repair work may only be carried out by VIRAX
WARRANTY
The VAL 80E pipe cleaner is guaranteed for 2 years, excluding parts subject to wear and tear.
Interventions or repairs by unauthorized workshops will cancel any warranty.
Page 15