Controls And Operation; Connections; Stylus Replacement; Cartridge Replacement - Vieta Home VH-TT500SL Manuel Utilisateur

Controls and Operation

1. Turn the (On/Off Switch) clockwise to turn on the
power, the speed indicator and the strobeilluminator,
which is located beneath the On/Off switch, will light
up.
2. Place a record on the slip mat. When playing a
45-rpm record with a large center hole, place the
45-rpm adapter on the center spindle.
3. Set the speed to match the record.
4. Remove the stylus protector from the Headshell
Stylus, release the Tonearm clamp.
5. Set the cueing lever to the up position.
6. Press the Start/Stop Button, the turntable platter
will start to rotate.
18
7. Move the tonearm over he desired groove.
8. Set the cueing lever to the down position, the
tonearm will descend slowly onto the record and
begin playing.
9. When play is finished, raise the cueing lever, move
the tonearm onto the Tonearm clamp.
10. Press the Start/Stop Button to stop the
platter from rotating. Turn the On/Off Switch
counterclockwise to turn off the power.
Suspend Play
Set the cueing lever to "UP" position during play, the
stylus tip of the cartridge will be lifted from the
record.
Turn-table

Connections

This set's phono cables and ground lead are
attached to the rear panel of the turntable. The phono
cable with the white plug is for the left channel and
the one with the red plug is for the right channel. The
thin wire with the Y-shaped connector at the end is
the ground lead.
This should be firmly connected to the ground
terminal on the mixer.
The way in which the phono cables are attached
will depend on the type of cartridge used. Read
the instructions in the booklet that comes with the
cartridge as well as the operating instructions of the
mixer and connect the phono cables properly.
Finally, plus the power cord into the power consent.

Stylus Replacement

The life expectancy of the stylus tip is 500 hours. For
the sake of maximum sound quality reproduction, we
recommend replacement within the minimum time
limit.
1. The stylus tip is replaced by grasping the stylus
holder and pulling it away from the body of the
cartridge.
2. The new stylus tip s then inserted by pushing it
into the receptacle.

Cartridge Replacement

Remove the headshell from thd tonearm, and the
screws that hold the cartridge. Pull out the four lead
wires from the cartridge itself. To protect the lead
wires at this point, remove the terminal pins with
pliers or the tip of the screwdriver.
The terminals on the accessory headshell are
aligned according to the arrangement below. Check
the location and polarity of each of the cartridge's
terminal pins and then connect the lead wires, taking
care not to get the polarities mixed up.
Red : Right channel
White : Left channel
Green : Right channel ground
Blue : Left channel ground
19
ENGLISH