Setting The Lighting Duration; Setting The Daylight Level; Aligning The Motion Detector; Cleaning And Care - LIVARNO LUX HG03847 Instructions De Montage, D'utilisation Et Consignes De Sécurité

pre-adjustments are made using the two control-
lers on the underside of the motion detector
(Fig. C).

Setting the lighting duration

Turn the TIME rotary control
tom side of the motion detector
to increase the duration of illumination. The
lighting duration can be adjusted within a
time window of approx. 10s +/- 5s –
4 min +/- 1min.

Setting the daylight level

Turn the LUX rotary control
side of the motion detector
increase the daylight level: In the position,
the motion detector only reacts at night (at
approx. 20 lx). In the
detector also responds at daylight levels, as
long as about 20,000 lx are not exceeded.

Aligning the motion detector

Note: Perform this adjustment at twilight.
Loosen the locking screw (motion detector)
Turn the LUX rotary control
Align the motion detector
region of the desired coverage area.
Move about through the coverage area until
you are satisfied with the response
10 GB/IE/NI
10
on the bot-
19
clockwise
10
on the bottom
20
clockwise to
10
position, the motion
.
9
to position .
20
into the central
10
characteristics of the motion detector
find the proper orientation, change the orien-
tation of the motion detector
When you have aligned the motion detector
satisfactorily, re-tighten the locking screw
to fix the adjustment.

Cleaning and Care

Before cleaning, remove the fuse or switch off
the circuit breaker at the fuse box.
Never immerse the product in water or other
liquids. Otherwise the product can be
damaged.
Clean the product with a lint-free, slightly
moist cloth and mild cleaning agent.
Re-install the fuse for this circuit or switch on
at the circuit breaker (I position) in the fuse
box.

Disposal

The packaging is made entirely of recyclable ma-
terials, which you may dispose of at local recy-
cling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
. To
10
.
10
10
9