Preparing The Product For Use; Switching The Motion Detector On And Off; Setting The Lighting Duration; Adjusting The Sensitivity Of The Sensor - LIVARNO LUX Z31171 Instructions De Montage, D'utilisation Et Consignes De Sécurité

preferable to those with slight deviations towards
the east.
Horizontal orientation:
The horizontal orientation of the solar cell depends
on the geographic latitude of the mounting location.
In central Europe, and angle of 30°–40° is ideal.
Drill 4 holes. Mount the solar cell by using
the dowel (ø 6 mm) and screws
21
(ø 3.7 x 28 mm). To do so, use the pre-finished
mounting holes (see Fig. E).
After mounting, check that the solar cell is fitted
securely.
Note: After mounting, orient the solar cell by
tilting it. The solar cell is fitted with a joint which
locks every 18° to permit orientation.

Preparing the product for use

Switching the motion detector
on and off
Slide the AUTO / OFF switch
position to switch on the motion detector
Slide the AUTO / OFF switch into the OFF posi-
tion to switch off the motion detector.

Setting the lighting duration

Turn the rotary control TIME
of the motion detector
the duration of the illumination. The lighting
duration can be adjusted within a time window
of approx. 10–60 seconds.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
of the motion detector
crease the sensitivity of the sensor.
Note: The motion detector responds to heat
radiation. When outdoor temperatures are low,
14
into the AUTO
4
.
6
on the bottom
10
clockwise to increase
6
on the bottom
9
clockwise to in-
6
it is more sensitive to body heat than when out-
door temperatures are warm. Be sure to regu-
late the sensitivity of the sensor over the course
of the year.

Setting the daylight level

Turn the rotary control LUX
the motion detector
6
the daylight level. In position , the motion
detector only responds at pitch-black night
(approx. 50 lx). In position , the motion
detector also responds at daylight levels, as
long as about 20,000 lx are not exceeded.
Orientating the motion
detector
Loosen the fastening screws
detector .
6
Turn the rotary control LUX
Orient the motion detector into the central
region of the desired coverage area.
Move about through the coverage area until
you are satisfied with the response characteris-
tics of the motion detector. To find the proper
orientation, change the position of the rotary
control SENS or the orientation of the
9
motion detector.
Re-tighten the fastening screws to fix the adjust-
ment.
Turn the rotary control LUX to the desired posi-
tion. These can be determined during the dawn
or twilight hours during which the spotlight
should respond. Slowly turn the rotary control
LUX clockwise until it reacts to movement within
the coverage area.
on the bottom of
8
clockwise to increase
of the motion
5
to position .
8
7
GB/IE 7