dirna Bergstrom bycool green line COMPACT 3.0 Instructions De Montage page 22

COMPACT 3.0
EN
6b
In the case of XLX cabin with spoiler TGX model,
position the unit on the hatch plate, inserting the
studs in the elongated boreholes of the plate so
the rear part of the unit is level with the seal. See
(B) of point 5a.
In this model, the unit is positioned with
!
the plate on the opposite side to the other
models, as shown in the measurements set
out in point 5a.
7
Position (1) the flat washer (1) and nut on each
stud and tighten firmly.
8 Via the front section, position the equipment
with the plate on the hatch of the vehicle. The
hatch plate must remain level with the EPDM
seal.
6b
6b
22
Air conditioning for vehicles
8