Scope Of Delivery; Unpacking The Appliance; Application Notes; Operation - Proficook PC-TAZ 1110 Mode D'emploi

Scope of Delivery

1. Automatic toaster with crumb tray (5) and integra-
ted roll top (8)
2. "Cool touch" sandwich tongs (6)

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging materials such as film,
filling materials, cable holders, and carton
packaging.
3. Check the scope of deliveries for completeness.
NOTE:
Dust or production residues may still be found on the
appliance. Clean manufacturing residues and dust
from the appliance as described under "Cleaning".
Application Instructions
Before Initial Use
CAUTION:
In order to remove the protective layer on the heating
coil, you should operate the machine approximately
three times while empty. Please select the maximum
level of browning.
NOTE:
Occurrence of light smoke and odors is normal with
this procedure. Ensure adequate ventilation.
Power cable (4)
Unwind the required power cable (4) from the bottom
part.
Electric Connection
Check that the mains voltage to be used matches the
voltage of the appliance.
You will find the information about this on the type
plate on the underside of the appliance.

Operation

• Only connect the unit to a properly installed and eart-
hed power socket.
• Adjust the degree of browning on the selector switch
(2) as required between the lightest level 1 to the
darkest level 7. If you are not sure, start with a lower
setting.
• Insert the slice(s) of bread into the toasting well (1)
and lower the slide with the lever (3) until it snaps
into place.
32
• The appliance starts the toasting. When the set level
of browning is reached, the appliance switches off
automatically. Then the slide (3) pops up automati-
cally.
Special Functions
For use of the desired special function, press the
relevant key, after pushing down the lever (3).
NOTE:
Heating or thawing:
The relevant pilot lamp (blue) indicates the function.
DEFROST (2) Defrost
REHEAT (2) Reheat
Stop (2)
Roll top (integrated) (8)
Want to warm up or toast some rolls?
Open the roll top (8) above the toasting wells (1) by
pushing the lever (7) at the rear of the toaster down.
Push the lever (7) up when warming of the rolls has
been completed.
CAUTION:
• Do not overload the roll top (8)! Never put more
than one roll into the roll top (8)!
• Set the selector switch for the degree of browning
(2) to level 3 max.
• Wait for one minute between toasting cycles.
• Never coat the roll with fat or butter. Fat could drip
down and ignite!
Sandwich tongs (6)
The sandwich tongs (6) are excellently suited for quick
and easy sandwich toasting.
• Press the handles of the sandwich tongs (6) together
and place the sandwich into the tongs (6). Then re-
lease the handles.
• Set the sandwich tongs (6) with the sandwich into
the toasting well (1) and use the lever (3) to lower
the slide as far as possible.
• Select the degree of browning to start toasting.
• Remove the sandwich tongues (6) after completion
of toasting.
• Do not forget: The sandwich tongs (6) are hot imme-
diately after toasting.
To thaw and then
toast deep-frozen
bread.
To reheat bread
already toasted.
To stop toasting early.