PCM BSC-510-3x-L Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank.
Then tighten the 2 screws of
fixations (Important, watch that the
screws have the same strength of
tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
BSC-510-3x-L
3. During the mounting or the dismounting
of your tools, block the broach on flats
planned for that purpose, using an
adapted wrench.
4.
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK :
empty positions. Use the supplied
protection plug
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 11.05.2016
The tool shank diameter should
never have a difference of more than
0.4 mm compared to the clamping
diameter of collet
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document :
BSC-510-3x-L 1-
Page : 2 de 4