Connection With The Mains; Operation; Stand Alone Operation; Master/Slave-Operation - Futurelight DJ-SCAN 300 Mode D'emploi

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the DJ-SCAN 300 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the DJ-SCAN 300 can be used without controller. You can do without a controller
as the DJ-SCAN 300 features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-SCAN 300 from the controller and select the desired "Master Mode".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.

Master/Slave-operation

Connect the master and slave-devices and adjust the settings as desribed above.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the light
output (control channel 6, DMX-value 250-255).

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the DJ-SCAN 300 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each DJ-SCAN 300
correctly and independently from any other fixture on the DMX data link.
If two, three or more DJ-SCAN 300 are addressed similarly, they will work similarly.
To set DMX address for the device, press the encoder and turn it clock-wise to increase the value and
counter-clockwise to decrease it. Press encoder again to confirm.
International
L
N
29/63 00030934.DOC, Version 1.3