LUMARK Crosstour LED Instructions D'installation page 3

Figure 5.
VISOR AND IMPACT GUARD OPTIONS
A. For visor installation only. Select the correct size lens
(Small: 7W, 18W, 26W models. Large: 38W model).
Remove protective film on the impact guard lens. Insert
the lens into the corresponding slots of the visor by
flexing the visor (Figure 6).
B. To attach the visor, select the correct visor size. Slide
the visor around the front Crosstour housing. The visor
ribs should rest on the bottom surface of the Crosstour
(Figure 6). Seat visor back tabs into the Crosstour fin
cavity (Figure 7). Insert the 8-32 x 3/4" long, thread
forming screw through the visor screw hole and tighten
until visor is secure. Tighten/torque to 20-25 in-lbs.
(Figure 8.).
15°
Installation Instructions - Crosstour LED Knuckle Kit
Lens fits in Visor slots here.
Figure 6.
Back tabs inserted into Crosstour back fins.
Figure 7.
Figure 8.
EATON
IB506005EN
Visor ribs
Installation instructions
3