afriso OM 1 Notice Technique page 64

5.3 Mounting the control unit
Mount the control unit to the wall using mounting type A or B.
Select a mounting position where the audible alarm signal can always be
heard, even in the case of ambient noise. 
If audibility cannot be ensured, you must install an additional alarm unit at a
suitable location in the building (for example, additional alarm unit ZAG 01,
horn KH 1 or combined alarm light and horn from AFRISO).
 Verify that the control unit is mounted to an even, rigid and dry wall at eye
level.
 Verify that the control unit is accessible and easy to oversee at all times.
 Verify that the control unit is protected against water and splash water.
 Verify that the control unit is not mounted in a humid room.
 Verify that the ambient temperature is not exceeded at the control unit.
 Verify that the control unit is protected from direct atmospheric influences
if it is installed outdoors.
Fig. 5: Control unit with mounting frame for panel mounting; right: control panel cut
out
Mounting
OM 5 / OM 5+1 / OM 1
EN
18