Teka LI4 1270 E Manuel D'instructions page 12

4.6 POWDER DETERGENT DOSES
Laundry with normal dirt
1. Choose a programme without prewash.
2. Pour the total amount of detergent shown on the pack into the main wash compartment of the detergent dra-
wer.
Very dirty laundry
1. Choose a programme with prewash.
2. Place ¼ of the recommended amount of detergent in the prewash compartment of the detergent drawer and
¾ of the detergent in the wash compartment.
Warning!
If no recommended doses are provided, for delicate items in synthetic fibre use from ½ to 2/3 of the recom-
•
mended dose for washing tough cotton fabrics.
Only neutral detergents recommended for wool should be used on the wool programme.
•
Use the doses recommended by the detergent producer.
•
4.7 LIQUID DETERGENT DOSES
1. Pour the dose required into the measuring cap supplied with the bottle of liquid detergent and place it in the
drum, or use the main wash compartment of the detergent drawer, fitting the insert provided.
2. The scale on the red insert is intended as an aid when deciding the dose of liquid detergent.
Warning!
Liquid detergents can be used, at the doses recommended by the producer, only for the main wash, i.e. in
•
all programmes without prewash.
4.8 DESCALERS
Descalers can be added to the prewash and main wash compartments as recommended by their producers.
Place the detergent in the compartments first, followed by the descaler.
4.9 PROGRAMMES AND FUNCTIONS
For advice on selecting programmes in relation to the type of fabric, refer to the "Programmes Table",
supplied with this manual.
4.10 SWITCHING ON THE APPLIANCE AND SELECTING THE WASHING PROGRAMME
To switch on the appliance and select the programme, proceed as follows:
1. Turn the programmes knob in either direction. This switches on the washing machine.
2. Select the washing programme. The time left to the end of the programme appears on the display. The sym-
bols on the display light up to identify the information shown.
3. The default spin speed values are shown. The initial settings can be modified using the button underneath the
sequence of spin speeds.
4. If spin speed
this value is set the appliance does not perform the final spin and the washing programme ends
with water in the tank.
Spin Speed selection
no spin cycle and the appliance will stop with the tank full. If
is set, there will be
EN
Time to end
11