USRobotics 7908A Guide D'installation page 6

Before You Begin
Note: For more information, you can also refer to the Support section of the USRobotics Web site:
www.usr.com/support
Note: Your model number is 7908A. It is important that you have your serial number written down
before you install the 8-Port 10/100Mbps Ethernet Switch. You can find your serial number on the
bottom label of the switch and on the side of the package. If you ever need to call our Technical
Support department, you will need this number to receive assistance.
Step 1. Connect the power adapter to the 7.5 VDC port on the switch, then
plug the power adapter into a standard power outlet.
Step 2. Connect your 8-Port 10/100Mbps Ethernet Switch to your Ethernet-
ready device.
Congratulations!
The installation of your USRobotics 8-Port 10/100Mbps Ethernet Switch is
complete. As connections are established with the 8-Port 10/100Mbps Ethernet Switch, the
corresponding LED lights will turn on. Repeat this step as needed for up to seven additional
devices.
2