Télécharger Imprimer la page

Dell Force10 S25 Systems Guide De Démarrage Rapide page 22

Publicité

Les langues disponibles

Les langues disponibles

Configure the Enable Password
The EXEC Privilege mode is accessed by the enable command. Configure a
password as a basic security measure. When using a console connection, EXEC
Privilege mode is unrestricted by default; it cannot be reached by a VTY
connection if no password is configured. There are two types of enable
passwords:
enable password stores the password in the running/startup configuration
using a DES encryption method.
enable secret is stored in the running/startup configuration in using a
stronger, MD5 encryption method.
Dell Force10 recommends using the enable secret password.
Task
Command Syntax
Create a password to
enable [password | secret] [level level]
access EXEC
[encryption-type] password
Privilege mode.
Create a VLAN
The Default VLAN is part of the system startup configuration, and is by default,
VLAN 1. You may make another VLAN the Default VLAN. The Default
VLAN cannot be deleted, disabled, or configured (you cannot assign it an IP
address), and only untagged interfaces can belong to it.
When an interface is configured, a switchport automatically places it in the
default VLAN as an untagged interface. All switchports must belong to at least
one VLAN, so to remove a switchport from the Default VLAN, you must place
it as tagged or untagged in some other VLAN, or remove the switchport
configuration.
Task
Create a VLAN
Display all VLANs.
20
Installing the Software
Command Syntax
Command Mode
interface vlan vlan-id
CONFIGURATION
show vlan vlan-id
EXEC Privilege
Command Mode
CONFIGURATION

Publicité

loading