Saci pumps SMART POOL Manuel D'installation Et D'entretien page 23

12. ADDITIONAL ELEMENTS
The additional elements for installation of the intelligent controller are:
• Wall mounting
• PT-100 temperature probe
a) WALL MOUNTING:
The wall mounting enables the intelligent controller to be fixed to the wall in insta-
llations in which the controller does not need to be directly connected to the motor's
terminal cover. In these situations it is very important to ensure the correct sizing of
the pump/intelligent controller electrical connection cable. The following table shows
the recommended cable selections based on the electrical power of the motor and the
distance:
MOTOR power HP
0,25 / 0,33
0,5 / 0,75
1 / 1,05
2 / 3
b) PT-100 TEMPERATURE PROBE:
The PT100 temperature probe is an element for detecting the water temperature in
installations in which there is a possibility that the pipes may freeze. To place the
probe into location, it is recommended that it is as close as possible to the swimming
pool and as far away as possible from the pump room. The temperature probe
has a ¼" male threaded connection, and it is recommended to install it on the
pump's pressure pipes.
It must be connected to electricity through the intake marked "PT100" on
the intelligent controller. For its operation, "INLET ON" must be selected
in configuration menu "9. INPUT/OUTPUT".
13. WARRANTY
The controller is guaranteed for 24 months from the purchase date. The use of original
spare parts, alterations or improper use will void the product guarantee.
14. DISPOSAL AND ENVIRONMENTAL ASPECTS
To remove the parts that make up the time controller, the current rules and regulations
in each country in which the product is used must be adhered to. In any case, do not
dispose of polluting parts into the environment.
Cable section (mm
1 1,5
Maximum distance (metres)
40 130
25 60
- 30
- 15
English
)
2
2,5
220
110
60
35
23