Publicité
I GB
FUNZIONAMENTO
OPERATION
This product is equipped with a receiver that allows operating it from a distance via remote control
(available as optional) or from the hob (sold separately).
If you do not have the remote control, follow the procedure below to disable the receiver and prevent
any interferences:
1 Unplug the device for at least 10 seconds
2 Plug it back in
3 Press the light key on the hood control panel until the lights turn on
4 Press the start key. If all the lights are off, it means that the receiver has been disabled successfully.
To re-enable the receiver, follow the remote control or hob pairing procedure.
TSL 3
B
1
3
4
A
2
General notes: Any function can be activated by pressing softly the button under the symbol.
A. ON/OFF light button: By essing this button the hood's lights switch on.
B. ON/OFF motor button: By pressing this button the extracting motor can be activated/stopped.
1.2.3.4. Speed regulator button: By progressing this button the hood activates the selected extracting
speed.
Funzione Timer: By pressing once again the Selectedspeed button,the timer will last for 5 minutes. This
function can be applied to all 4 available speeds.
Grease filter saturation: After every 40 hours of use of the hood, the button B or 3+4 indicator shows
byflashing slowly that the grease filters need to be washed.
Charcoal filter saturation: After every 120 hours of use of the hood, the button B or 3+4 indicator by
flasihing fast shows that the charcoal filters need to be replaced.
Note: By pressing for at least 5 minutes the button 3+4 will reset the filters saturation indicator.
Attention! This function should only be used after performing the maintenance of the filters.
Automatic functioning through the heath sensor:
By pressing the button 1 2 at the same time, the hood starts the automatic functioning. The indicators
of the 4 speeds will flash in sequence . After more or less 30 seconds the temperature sensor will start
the motor choosing the right extracting speed.The speed will change according to the heath coming
from the hob.
By pressing B the manual functioning can be restored.
Always clean the glass of the control for a correct functioning.
All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for 7 minutes, after
which it automatically returns to the last non-timed speed.
42
Publicité
