Table Des Matières - Amprobe FG2C-UA Mode D'emploi

ENGLISH
CONTENTS
CERTIFICATIONS AND PRECAUTIONS ............................................................................................................... 1
FOR UNITED KINGDOM ONLY .......................................................................................................................... 1
PREPARATION FOR USE - UNPACKING............................................................................................................. 2
INTRODUCTION ................................................................................................................................................. 2
FEATURES COMPARISON TABLE FOR MODELS ................................................................................................ 2
CONTROL DESCRIPTIONS .................................................................................................................................. 7
USAGE PROCEDURES ......................................................................................................................................... 8
PRECAUTION ITEMS .......................................................................................................................................... 8
FUSE REPLACEMENT (See Figs. 2 and 4) ........................................................................................................... 9
MAINTENANCE .................................................................................................................................................. 9
SPECIFICATIONS ............................................................................................................................................... 10
CERTIFICATIONS AND PRECAUTIONS
This instrument is EN61010-1 certified. All inputs are protected against continuous overload conditions up to the
limits of each function's stated input protection (see specifications). Never exceed these limits or the ratings marked
on the instrument itself. Always inspect your Function Generator, test leads and accessories for signs of damage
or abnormality before every use. If an abnormal condition exists (broken or damaged test leads, cracked case,
display not reading, etc.), do not use. Never ground yourself when taking measurements. Do not touch exposed
metal pipes, outlets, fixtures, etc., which might be at ground potential. Keep your body isolated from ground and
never touch exposed wiring, connections, test probe tips, or any live circuit conductors. Do not operate instrument
in an explosive atmosphere (flammable gases, fumes, vapor, dust.) Do not use this or any piece of test equipment
without proper training.
�
DANGER High Voltage
�
ATTENTION Refer to Manual
Protective Conductor Terminal
Frame or Chassis Terminal
�
Complies with EU directives
FOR UNITED KINGDOM ONLY
NOTE: This lead/appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are coloured in accordance with the following code:
Green/ Yellow: Earth
Blue: Neutral
Brown: Live (Phase)
�
�
�
�
�
E
L
N
1
WARNING: To avoid electrical shock, the
power cord protective grounding conductor
must be connected to ground.
CAUTION: To avoid damaging the instrument,
do not use it in a place where ambient
temperature exceeds 40°C.
CAUTION:To avoid damaging the instrument,
do not input more than 15VDC to VCF.
CAUTION: To avoid damaging the instrument,
do not input more than 150VAC to Frequency
Counter (FG3C-UA only).
CAUTION:To avoid damaging the instrument,
do not input more than 10Vpp during EXT
modulation operation (FG3C-UA only)