Bedienungsanleitung / Owner Manual 4000 Pro
Assembly Instructions
Place the unit in the vertical position as shown.
1. Fit the wheel axle to the base machine using
the screws shown but do not tighten up. .
2. Slide the mudguard into position between the
chassis and axle brackets. Now fully tighten
the four fixing bolts.
3. Attach the wheels to the axle and secure
using washers and split pins.
4. Lift up the foot stand (as shown arrowed) and
tighten the fixing screws.
5. Fit the two handles to the chassis, tighten the
fixing screws and rotate the machine into a
horizontal position..
6. Attach the main hopper to the top of the
machine using the hinges and the short black
hand screw supplied.
7. Attach the discharge hopper, snap it shut and
fix using one long black hand screw.
8. Secure the side hopper with the collar bolt
and secure with the second long black hand
screw.
Fill the petrol engine with correct grade oil as
shown in the engine manual and full before
attempting to start.
Important:
Do not attempt to use this machine without
having
first
studied
Operators
manual
Instruction
Information
features.
Safety devices
1. You will find safety switches (3) + (4) located
on the side hopper as well as on main intake
hopper and the discharge cover. Safety
screws (1) + (2) operate the switches, so
that the machine cannot start until all
hoppers and covers are all correctly fitted.
Under no circumstances should any changes be
made to any of these safety devices.
In both hoppers there is
prevent material being ejected. The should be
inspected on a regular basis and replaced when
worn.
A feed tool is provided to enable leaves and
bulky material to be safely fed into the machine.
This is stored at the side of the main
Herkules Motorgeräte
both
the
Engine
and
the
Shredder
and
safety
a rubber flap to
www.herkules-garten.de
12