Clatronic TK 2932 Mode D'emploi page 36

GB
1 Lid
2 Water outlet cover
3 Covering grid
4 Tea strainer
5 Ascending pipe
6 Teapot
• Please read these operating instructions carefully and keep them in a safe
place.
• Before using the teapot (6) for the fi rst time please rinse it out once, fi ll it with
fresh water twice and boil. Use only water without any additives or ingredients.
The device can be used to boil water or prepare tea. If you only wish to heat up
water please remove the entire fi lter insert.
Electrical Connection
• Check whether the mains voltage supply that you intend to use is the same as
that of the kettle. For information on the voltage supply of the kettle, please see
the identifi cation plate on the base.
• Only connect the machine to a properly installed 230 V, 50 Hz safety socket.
• Make sure that the appliance is switched off (The light (9) in the I/O switch is
off).
1. Place the device on a fi rm, fl at surface. Position it so that it cannot tilt over.
2. Please remove the lid (1) and fi ll with clear water. You can read off the level to
which it is fi lled using the water level indicator. Please do not overfi ll the kettle.
3. Close the lid until it is heard to lock into place and is fi xed fi rmly in position.
Note the position of the recesses on the edge of the lid. Position the lid such
that the wavy side is above the spout.
4. Place the kettle fl ush on the base.
5. Turn the device on with the I/O switch (9). The control lamp in the switch and
the control lamp (10) light up.
6. The water begins to boil. Once the temperature has been reached the control
lamp (10) goes off.
7. The device switches on automatically as soon as the temperature of the water
falls; the control lamp (10) goes on again. After the water has boiled please
switch the device off.
8. In order to remove the lid, please pull the lid by the button that is located on it
and not by the edge of the lid. Danger of burns!
36
6....-05-TK 2932 36
Overview of the Components
First Use of the Machine
Using the Kettle
7 Handle
8 Heating element
9 I/O On/off switch
10 Control lamp
11 Base
12 Mains lead
22.02.2005, 12:06:19 Uhr