Table Des Matières; Product Specifications - Porter Cable PCB575BG Manuel D'instructions

SECTION
PRODUCT SPECIFICATIONS .......................................................................................................................
CALIFORNIA PROPOSITION 65 ...................................................................................................................
SAFETY GUIDELINES - DEFINITIONS .........................................................................................................
POWER TOOL SAFETY .................................................................................................................................
BENCH GRINDER SAFETY ...........................................................................................................................
ELECTRICAL REQUIREMENTS AND SAFETY ............................................................................................
TOOLS NEEDED FOR ASSEMBLY ...............................................................................................................
CARTON CONTENTS ....................................................................................................................................
KNOW YOUR BENCH GRINDER ..................................................................................................................
ASSEMBLY AND ADJUSTMENTS .................................................................................................................
OPERATION ..................................................................................................................................................
MAINTENANCE .............................................................................................................................................
TROUBLESHOOTING GUIDE........................................................................................................................
ACCESSORIES AND ATTACHMENTS ..........................................................................................................
PARTS LIST ...................................................................................................................................................
WARRANTY ...................................................................................................................................................
MOTOR
Power source ........ 120 V AC, 60 HZ, 5 A
Horsepower ........... 3/4 HP
Speed .................... 2000 ~ 3400 RPM
Type....................... Induction
Shaft diameter ...... 5/8 in. (15.88 mm)
Switch .................... ON/OFF
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection. Use a separate electrical
circuit for your tools. The grinder is wired at the factory for 110-120 Volt operation. It must be connected to a 120 V,
5 AMP branch circuit and use a 5 AMP time delay fuse or circuit breaker. To avoid shock or fire, replace power cord
immediately if it is worn, cut or damaged in any way.
WARNING
!
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemical: work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles. Avoid prolonged contact with
dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing
and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin
may promote absorption of harmful chemicals.
WARNING
!
Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or
other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure.
Direct particles away from face and body.
2010/01
TABLE OF CONTENTS

PRODUCT SPECIFICATIONS

CALIFORNIA PROPOSITION 65
WHEEL
Diameter .......................... 8 in. (200 mm)
Face ................................ 1 in. (25 mm)
Hole ................................. 5/8 in. (15.88 mm)
LIGHT BULB (not included)
2
PAGE
2
2
3
4
5
7
8
8
9
10
13
15
16
17
18
20
40 W (maximum)
Printed in China