Hague Quality Water MicroBoss II Manuel Du Propriétaire Et Manuel D'installation page 32

Assembly and Parts, Cont.
Brine Valve Housing Assembly
Part #
1 53511
2 90821
3 53510
4 90843
5 93805
6 93243
7 90818
93601
53511 Brine The Piston should have an O-Ring on the shaft side of the flange and a spring pressed onto a boss on
Piston the other side. The O-Ring should be free of defects such as cuts or debris on the shaft side.
53510 Housing Just inside the entrance hole for the Brine Piston (53511) is a concave seat area that must be free of
defects such as nicks, indentations, or debris. This seat area ensures a leak-free seal for the static
O-Ring on the Brine Piston. If any defects are detected by visual inspection, repair or replace as
needed.
90843 0.5 gpm The Flow Button has two distinct and different sides. One is "flat"; the other is "concave." The button
(1.9 L/min) Flow should be centered in the housing opening with the four locator "ribs" with the concave side facing the
Control Housing End Cap—Barbed (93243).
93243 Housing The Cap is held in place by two 3/4-inch (19-mm) self-tapping screws that engage the Housing flange.
End Cap An O-Ring seals the Cap and Housing. Place the O-Ring into the housing opening, lubricate with
silicone grease and then using a twisting action, pressure insert the Cap.
Model 410 Owner's Manual
Concave side
Static O-Ring
Figure 24: Brine Valve Housing Assembly
Brine Piston Assembly (includes O-Ring & Spring)
O-Ring
Housing
0.5 gpm (1.9 L/min) Flow Control
O-Ring
Housing End Cap (Barbed)
Screw, self-tapping
Entire Assembly (all of the above parts)
Description
6/16/2014
Quantity
1
1
1
1
1
1
2
31