Marmitek FLAT TV LINK 4 Guide Utilisateur page 4

nieuw NL3 02-09-2004 16:41 Pagina 6
Use the table below to choose which connection cables/plugs you need to use
Composite video and
mono audio (e.g. a VCR)
Composite video
and stereo audio
(e.g. DVD player, camcorder)
S-video (S-VHS) and
stereo audio
Scart
Scart and digital
optical audio
Using the device
1. Connect the power adapter (included) to connection (6).
2. Plug the adapter into a 230V wall socket. You will now see a red light on the Flat TV Link 4.
3. Connect your (flat screen) TV to the Out connection on the Flat TV Link (5) to correspond
with the In connector used (Scart, S-video or RCA).
Note: if you are using an S-video cable, you need to connect the audio signal to the TV
via an RCA cable, because S-video does not transmit audio signals.
4. Connect all your equipment to the In connection
(corresponding with the chosen Out connection).
5. Turn on your TV and select the A/V or external channel
(check the user manual of your TV).
6. Switch on the Flat TV Link using the On/Off/Standby button on the front (1).
You will now see a green light.
7. Use the remote control or the option buttons on the front (3) to select the In channel.
You can step through the 4 In channels by repeatedly pressing the button.
6
Connect the video connector to the yellow Video In
(8) and the audio signal to the white Audio In (9).
Connect the video connector to the yellow Video In
(8), the left audio signal to the white Audio In (9)
and the right audio signal to the red Audio In (10).
Connect the S-video connector to the 4-pin Mini DIN
In (7), the left audio signal to the white Audio In (9)
and the right audio signal to the red Audio In (10).
Connect your Scart cable to the Scart In (11). With
stereo audio you need to use full 21-pin Scart cables
(1 included).
Connect your Scart cable to the Scart In (11) and the
optical cable to the Optical Connection (12). First
remove the dust cover. Replace the dust cover when
not using the optical connection.
Troubleshooting
1. I cannot turn on the Flat TV Link with the remote control or the On/Off button:
- Check whether the power adapter has been connected properly and the wall socket is
working.
- If you see a red light on the On/Off/Standby button, the Flat TV Link is in standby mode.
Press the On/Off button on the front of the device or the remote control again.
2. The Flat TV Link is switched on, but there is no image:
- Make sure the Flat TV Link is connected properly and the TV is set to the A/V or
external channel. Try connecting one of the devices directly to the same connection.
- Check the connections on the back of the Flat TV Link.
3. The sound is not working:
- Check the connecting cables.
- Check the volume setting of the TV.
- Check whether the audio signal is transmitted by the cable used (S-VIDEO cables or
partially pinned Scart cables do not transmit audio).
4. The image is very grainy/there is background interference:
- Switch off equipment which is not being used. Sometimes equipment gives off a very
strong signal, which can cause interference.
- Check the quality of the cables used.
5. Replacing the battery of the remote control:
Follow the instructions on the back of the remote control and replace the battery with a
battery type CR2025 (3V). Check the polarity (+/-) when positioning the battery.
MARMITEK FLAT TV LINK 4. tm 7