HQ EL-PILRLA90 Mode D'emploi page 3

Note: Please bring the following tools
Pencil Electric drill Hammer Screwdriver
1. Mark the wall where you wish to mount the light.
2. Drill all four holes.
Place the mount on the wall with nylon anchors (if needed) and screws.
3. Please connect the battery according to the diagram in the warning part of the instruction book,
and assemble the battery cover as it was.
4. Slide the light into the mount, then screw in the bottom bolt.
5. Mount the solar board with screws. Adjust the direction it faces.
3