Wurth Master EWS 7-115 Notice D'utilisation page 14

EWS 115..book Seite 14 Dienstag, 15. Mai 2007 11:18 11
Angle Grinder
Article number
Rated power input
Output power
No-load speed
Grinding disc dia., max.
Grinder spindle thread
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries, these values
can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Machine Elements
1 Spindle lock button
2 Grinder spindle
3 Protection guard
4 Mounting flange with O-ring
5 Grinding/cutting disc*
6 Clamping nut
7 Two-pin spanner for clamping nut
8 On/Off switch
9 Auxiliary handle
10 Release lever
* Optional accessories
Not all of the accessories illustrated or described are included
as standard delivery.
Intended Use
The machine is intended for cutting, roughing and
brushing metal materials. The machine is not
intended for working with diamond cutting heads.
For damage caused by usage other then intended,
the user is responsible.
Information on Structures
Slots in structural walls are subject to the Standard
DIN 1053, Part 1 or country-specific regulations.
These regulations are to be observed under all cir-
cumstances. Before beginning work, consult the
responsible structural engineer, architect or the con-
struction supervisor.
14
Tool Specifications
EWS 7-115
0702 474 X
750
[W]
360
[W]
11 000
[rpm]
115
[mm]
[mm] M 10
[kg] 1.5
Mounting the Protective Devices
Disconnect the mains plug from electric supply.
Protective Guard
For work with roughing or cutting discs, the protec-
tive guard 3 must be mounted.
3
10
Note: Coded notches on the protective guard 3
ensure that only a protective guard that fits the
machine type can be mounted.
Auxiliary Handle
For all work with the machine, the auxiliary
handle must be mounted.
Screw the auxiliary handle 9 on the right or left of the
machine head depending on the working method.
EWS 7-125
0702 475 X
750
360
11 000
125
M 10
1.6
/ II / II
Open the clamping lever 10.
Place the protective guard 3 with
coded cams into the respectively
coded grooves on the spindle col-
lar of the machine head and turn
anti-clockwise to the required po-
sition (working position).
To fasten the protection guard 3,
close the clamping lever 10.
The closed side of the protection
guard 3 must always point to the
operator.