Electrical Connection - Frigelux TT90VCM Notice D'utilisation

• Your appliance has been designed for optimum functioning at a certain ambient temperature; it is designed
for a particular climate class. This climate class is clearly indicated on the identification plate situated on the
inside of your appliance, low down on the left wall. Outside of this temperature range, the performance of your
appliance may be reduced.
• Leave a minimum distance between your refrigerator and your other units of 3 to 5cm at the sides and 10cm
at the top, to maximize air circulation around the appliance.
• Position the appliance at a suitable distance from the wall.
Class Ambient temperature
SN from + 10°C to + 32°C
N from + 16°C to + 32°C
ST from + 16°C to + 38°C
T from + 16°C to + 43°C
Advise:
Once you have installed your appliance, adjust its feet so that it is tilting backwards slightly, this helps
the door to close correctly.
Before placing any food in your appliance, clean it inside and out with a bicarbonate of soda solution
(1 dessert spoon of bicarbonate to 4 litres of water). Do flot use alcohol, scouring powder or
detergents, which could damage the surfaces. See the section on "Cleaning your Appliance".
Moving your appliance
Be sure the appliance stays in upright position during moving it.
Do not tilt it for more than 45°from upright. Never upset it.
Do not apply force on any external part such as pipe, condenser, door and its handle for moving, freezer must
be well packed and secured in long distance transportation to avoid damage from impacting and or great
rocking.

ELECTRICAL CONNECTION

Attention :
Attention:
For your own safety, you must comply with the instructions given below.
Electrical installation must comply with Standard NF C *15-100, in particular concerning the Earth.
Three-core flex 3x2.5 mm2, 230V single-phase connected to:
- 20A single-phase 230V-50Hz supply
- ELCB and an individual fuse (10 or 16A depending on the model)
We cannot be held responsible for any incident caused by faulty electrical installation.
Recommendations for the electrical installation of your appliance:
• Do not use extension leads, adaptors, or socket strips.
• If the power cable is damaged, do not replace it by yourself, and contact your after sales service
• Always make sure your circuit is earthed.
• The socket must always remain accessible, yet be out of the reach of children.
If you have any doubts, contact your installer.
Your appliance is compliant with European Directives as their modifications.