Publicité
Les langues disponibles
Les langues disponibles
Getting started
∙ Unwind the cable from the cable storage und plug it in.
∙ Open the lid, fill the device with water and close the lid.
∙
Do not fill the above the maximum marking on the water gauge because
hot water can escape.
∙ Place the container onto the base, the device beeps 2 times and the LED shines.
∙ Press the ON/OFF button, the LED shines.
∙ The device starts with the 100°C mode and starts heating. Once the temperature is
reached, the device beeps twice and the LED turns off.
∙ Setting the temperature:
o Choose the desired temperature 50, 70, 80, 90°C with the selection button.
A coloured LED indicates the corresponding temperature.
o Press the OON/OFF button, the device starts heating.
o Once the temperature is reached the device beeps twice and the LED turns
off.
∙ Keeping warm function:
o If the set temperature should be kept for 30 minutes, press the ON/OFF
button for 5 seconds during the setting process. The LED on the panel
flashes, the water gauge shine coloured corresponding to the selected
temperature. The devices turn off after 30 minutes.
Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with pro-
blems that may occur when using your device. For many problems there is a simple
solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem
Control light does not
shine once device is
plugged in
Boiling result is bad
Device turns off
Reason
∙ No power
∙ To many devices at one
power cord
∙ Lid is not closed prop-
erly
∙ Heating plate is calci-
fied
∙ Due to scale, heat ac-
cumulates and triggers
the microswitch
Solution
∙ Check is plug is
plugged-in correctly
∙ Check the fuse
∙ Close the lid
∙ Decalcify the device
∙ Leave to cool for 10
minutes.
∙ Descale
13
Publicité
