-Displaying The Tan Φ; Cosϕ / Tan Φ Setpoint Setting - Alpes Technologies LEGRAND ALPIMATIC Notice D'installation

You can, if you wish, regulate the capacitor bank by displaying the Tan Phi of the network and setting a
Tang Phi setpoint:
From the man page press
Go to manual mode by selecting
Press again
Select menu «
Select parameter
With or set parameter to ON (MAX) then validate with
◄ ►
Select parameter
With or choose the setpoint Tan Phi to be reached by controller and validate with
◄ ►
Press twice the controller resets. The log TAN φ appears (parameter 9 of main page)
◄,
Press to access the main menu
Switch to automatic mode by selecting
Nota : any modification of the parameters of the power factor controller(except parameter
P02.30 & P02.31) cancels the manufacturer warranty for the whole equipment.
According to the measurement you have selected (cos ϕ or tan ϕ) you can adjust the setpoint value:
From the man page press 3 times
Use keys or
◄
Press key to validate and return to the main page
________________________________________________________________________________
9 – DISPLAYING THE TAN PHI
key to access the main menu
to go back to the menu page and select
M02 GENERAL
» with
P02.30 Tan phi setpoint enable
«
P02.31 Tan phi setpoint
«
10– COSϕ / TAN ϕ SETPOINT SETTING
▲
to select the required setpoint value
►
and validate with
and validate with
▼
» with
» with and validate with
▼
with
and validate
to access the menu page
Page 38
_
key
key with then validate with
◄
key
then validate with
▼
key
key
key
key
key